swampy wrote:Clutchless is OK if you get it right, and at the right times. I do use the clutch going up when riding slowly and in town. When getting a move on, and higher in the revs a couple of mm off-throttle and a toe forward results in a quick, smoth and positive change.
It works for me and I know that it has the potential to wear the selector ?guides? but I've never had a problem. Then again I don't tend to keep my bikes very long.
This is my take on it, I'm sure someone will have a different view.
Although sometimes I subconsiously give the clutch a two fingered dab when bouncing off the limiter on the way up,
I tend to find I hardly use the clutch at all up or down when nipping on off road on the enduro but am on it all the time in the knarly stuff through the trees.
tho I do tend to keep bikes I like for quite a few years and even tho I do tend to have to rebuild quite them quite often this has never been a cause for a repair yet
remember reading this post and thought sore wrists and pins and needles was down too riding position ect
went too docs today and reason nothing too do with position on bike but carpal tunnel syndrome
wish was just riding position as could have changed that
Carpal tunnel is what a lot of racers suffer with. More commonly known as arm pump.
If pins and needles, some folk find putting heavier bar end weights on can stop this tingling, as the bike must be in that annoying rev range where there is a vibration going through your bars.
As for sore wrists, you a probably gripping onto the bars too tightly. Try loosening your grip slightly. You will probably need to conciously be aware of doing this.
I noticed that on the R1, i would get a sore left wrist if going through town where i was stop starting, but was more down to having shorter levers, and holding in the clutch lever.
As for shiftless changes, do this most of the time when going up the box, but as Grant says, not 1st to 2nd, as it is jerky. Use clutch all the time going down box.
teamemmenracing wrote:clutch lever is a good idea .......
other one is riding position ... idea is to have no weight at all on your wrists, try finding a position where your supported entirely by bum, feet, knees, tank ........ elbows should be well bent, not straight. If you can do that, you may find that the bike steers a lot sharper as well ........
what do I know anyway ...... just an idea
Got to agree, just relax. Easiest way I can describe it is to lay your hands on the handlebars as opposed to gripping them to death. Your elbows should be below the height of your hands, again arms relaxed which should in turn relax your shoulders/upper body.