AberdeenBikers

I've got an old B M W K100 that I've been restoring (mainly due to boredom and not being arsed with decorating the house).
The front exhaust port on the cylinder head is cracked (it's an inline 4), the head is aluminium.

I know the heat imput would have to be fairly high, and also quite localised, any chances of welding this without warping the cylinder head?

Or would I be better off just trying to track down another one?

Aitkens sheet metal (Harbour area) used to do aluminium welding - take the head in and see what they think.
Like you said tho - alot of heat involved might warp the head.
Nothing to lose?

Job like that would normally get cooked first then welded hot and cooled down at a controlled rate, then you should get it skimmed, even if you only take off a few thou, just to make sure it is flat.

You could give Simon Linford a bell. He owns SAS Precision Engineering in Meigle. If it can be repaired he'll do it. This guy is poo hot and makes flywheels etc for some British Motorcycles.

01828 640525

speedaddictedberk wrote:I've got an old B M W K100 that I've been restoring (mainly due to boredom and not being arsed with decorating the house).
The front exhaust port on the cylinder head is cracked (it's an inline 4), the head is aluminium.

I know the heat imput would have to be fairly high, and also quite localised, any chances of welding this without warping the cylinder head?

Or would I be better off just trying to track down another one?

should maybe try aberdeen head shop or falconer at blackburn.

garymitch wrote:should maybe try aberdeen head shop

Is that down the docks?

Aberdeen Head Shop
6, Stell Rd, Aberdeen, Aberdeenshire AB11 5QR
Tel: 01224 582014

here you go bud