Page 1 of 1
Machining
Posted: Thu Apr 01, 2004 9:28 am
by speedaddictedberk
has anyone got access to a Lathe?
i got aluminium spacer rings for the forks on my bandit (more preload) but they're 20mm....... which gives a fairly exiting ride.
so i'd like to trim them (and i dont trust myself with a hacksaw!) to 10mm.
cheers folks
Re: Machining
Posted: Thu Apr 01, 2004 10:32 am
by al
speedaddictedberk wrote:has anyone got access to a Lathe?
i got aluminium spacer rings for the forks on my bandit (more preload) but they're 20mm....... which gives a fairly exiting ride.
so i'd like to trim them (and i dont trust myself with a hacksaw!) to 10mm.
cheers folks
Did you change to 15wt oil at the same time????
The spacers are to correctly set the static sag on the forks.
Posted: Thu Apr 01, 2004 10:43 am
by Shrek
Big Kneed Al (master of the emergency stop & "stand up" comedian) you should change your name to “The sheriffâ€￾
Every time a Bandit is mentioned your there… do you receive text alerts or something?
:I can't believe it's not butter!
Posted: Thu Apr 01, 2004 10:46 am
by al
Shrek (formaly known as scotty) wrote:Big Kneed Al (master of the emergency stop & "stand up" comedian) (Super Nanny) you should change your name to “The sheriffâ€￾
Every time a Bandit is mentioned your there… do you receive text alerts or something?
:I can't believe it's not butter!
This town Isn't big enough for the both of us!!!
